- #Clonezilla image restore from network how to
- #Clonezilla image restore from network install
- #Clonezilla image restore from network iso
- #Clonezilla image restore from network download
- #Clonezilla image restore from network mac
nomorems) and then choose the disk you want to save it to. When computer M finishes the network boot, if you do not enter image and device name when running "dcs" -> clonezilla-start -> clonezilla-save-disk, a prompt will ask you to name the image and choose the device.Turn on computer M, set it as network boot (PXE or etherboot) in the BIOS or by pressing the hotkey (refer to your motherboard manual) when it is booting.Next, choose"clonezilla-save-disk" (use space key to mark it) run "dcs", then choose "clonezilla-start" (use the space key to mark it).Set the Clonezilla server to be clonezilla-save-disk mode: In the Clonezilla server,.
#Clonezilla image restore from network how to
#Clonezilla image restore from network mac
When setting up the DRBL server, it is recommended to collect the MAC addresses of the client computers and let the DRBL server offer the same IP address for the clients every time it boots. For how to use the latter mode, you can refer to here. During the configuration, you can choose to use the OS on the server as client's working environment when doing Clonezilla imaging/cloning job, or to use Clonezilla live as the OS of client in Clonezilla SE.
Once DRBL is installed on the server, Clonezilla is ready. The setup might take about 30 minutes to a few hours, it depends on your internet bandwidth.
#Clonezilla image restore from network install
To install and configure a DRBL server, check this installation doc then follow it to setup such a Clonezilla server.
#Clonezilla image restore from network iso
Then you can burn the iso file to a CD/DVD with any burnning program, such K3b on GNU/Linux or InfraRecorder on MS Windows, and remeber to choose "Burn Image" to burn the ISO file on the CD. The former one is for CD, the latter is for USB flash drive.ĭownload an ISO file for CD/DVD. Two types of files are available, iso and zip.
#Clonezilla image restore from network download
To put DRBL live on boot media (CD or USB flash drive), the basic steps are to download pre-build DRBL Live then put it in a boot media (CD, USB flash drive or USB hard drive).